radius for the proximity waypoint indicated.
Proximity List FullYou have used all nine
proximity waypoints.
Proximity Overlaps Another Prox WptThe
alarm radius specified overlaps the area specified
for another proximity waypoint. (See section 10
for more information on proximity overlaps.)
RAM has FailedThe random access memory
has failed and the unit is not operable. Take
your unit to an authorized GARMIN service cen-
ter for repairs.
ROM has FailedThe units permanent memory
has failed and the unit is not operable. Take
your unit to an authorized GARMIN service cen-
ter for repairs.
Received Invalid WaypointA waypoint was
received during upload transfer that has an
invalid identifier.
Receiver has FailedA failure in receiver hard-
ware has been detected. If this message persists,
do not use the unit and take it to an authorized
dealer for repair.
Route Already ExistsThe route number you
are trying to copy to is already used.
Route Does Not ExistThe route number you
are trying to use or copy is not defined.
Route is FullYou have attempted to add more
than 30 waypoints to a route.
Route Memory is FullYou have attempted to
create more than 20 routes.
Route Waypoint was DeletedA route waypoint
entered does not exist in the database and has
been deleted from the route.
RTCM Input has FailedDGPS data being
received has been lost. You are no longer receiv-
ing the beacon signal.
Searching the SkyThe GPSMAP 185 Sounder
is searching the sky for almanac data.
Shallow Water AlarmThe depth is equal to or
less than the set alarm depth.
Sonar ASIC has FailedThe units internal mon-
itoring system indicates a malfunction. Send in
for service as soon as possible.
Stored Data was LostAll waypoints, routes and
almanac data has been lost due to internal bat-
tery failure.
There is No RTCM InputThe beacon receiver
is not properly connected or baud rates do not
match.
Timer Has ExpiredThe countdown timer has
expired.
Track Memory is FullThe track memory is full
and no additional track plot will be recorded
until the track memory has been cleared or set to
wrap mode.
Transducer-Sounder Turned OffThe transduc-
er signal is not reaching the unit because of a
loose connector, bad wiring, or transducer mal-
function.
Wpt Already ExistsThe waypoint name youve
entered already exists in memory.
Waypoint Memory is FullYou have used all
250 waypoints in the GPSMAP 185 Sounder sys-
tem.
89
SECTION
C
APPENDIX
Messages
