GPSMAP
®
6000/7000 Series Owner’s Manual
Almanac, Environmental, and On-boat Data
Depth Data
Viewing the Depth Graph
The chartplotter must be connected to a depth-capable transducer to capture the data shown on the
depth graph.
From the Home screen, select
Information
>
Graphs
>
Depth
.
If you have turned on and configured the shallow water and deep water alarms (
graph shows in red any water depth data that is less than the depth specified for the shallow water
alarm, and it shows in red any water depth data that is greater than the depth specified for the
deep water alarm.
On-boat Data
Engine Gauges
Viewing Engine Gauges
You must be connected to a NMEA (National Marine Electronics Association) 2000 network capable
of sensing engine data to view engine gauges. See the
GPSMAP 6000/7000 Series Installation
Instructions
for details.
From the Home screen, select
Information
>
engines
.
Cycling Through Engine and Fuel Gauge Screens
1. From the Home screen, select
Information
>
engines
.
2. Move from one gauge screen to the next:
For the GPSMAP 6000 series, use the
Rocker
.
For the GPSMAP 7000 series, select the left and right arrows at the top of the page.
The chartplotter shows the next engine gauge or fuel gauge screen.
3. Repeat step 2 to cycle through all the engine gauge and fuel gauge screens.
Customizing Engine and Fuel Gauge Limits
You can configure up to four values for each engine gauge or fuel gauge, to establish the upper and
lower limits of the gauge, and the range of desired standard operation. When a value exceeds the
range of standard operation, the gauge face or bar becomes red.
Setting
Description
Scale minimum
This value is less than the scale minimum, and it represents the lower limit of the gauge.
This setting is not available on all gauges.
Scale maximum
This value is greater than the scale maximum, and it represents the upper limit of the
gauge. This setting is not available on all gauges.
Rated minimum
Represents the minimum value of the standard operating range.
Rated maximum
Represents the maximum value of the standard operating range.
1. From the Home screen, select
Information
>
engines
>
Menu
>
Gauge Setup
>
Set Gauge
Limits
.
2. Select a gauge.
3. Select
Mode
>
Custom
.
•
•
