To attach the yoke mount to the control yoke:
1. Loosen the lower knob.
2. Slide the clamp over the control yoke shaft just behind the control
wheel.
3. Tighten the lower knob securely.
4. Make sure that the clamp is as close as possible to the control
wheel and check to make sure that the yoke travel is not limited
or hindered in any way by the yoke mount.
5. If it is necessary to change the direction of the clamp, completely
loosen and remove the upper knob, then mate up the appropriate
sets of teeth so the clamp opens to the left or right (for conven-
tional yokes), or toward the instrument panel (for Baron or
Bonanza yokes or conventional control arms).
6. Tighten the upper knob.
7. Loosen the clamp adjustment knob enough to slide the clamp
over the control yoke shaft or arm.
8. Tighten the clamp over the control yoke shaft or arm using the
clamp adjustment knob.
The yoke mount includes a mounting bracket which is used to
secure the GPSMAP 195 during flight.
Using the Mounting Bracket
To secure the GPSMAP 195 using the mounting bracket:
Note: The unit is most easily inserted into the bracket holder by
placing the right side of the unit into the bracket first, then lowering
the left side in until it locks into place..
1. Slightly spread the sides of the bracket holder and insert the unit,
mating the four notches on the sides of the unit with the four tabs
on the bracket holder. Lock the unit in place by pushing in and
turning the lock/unlock knob located on the side of the bracket
holder to the lock position. Note: When removing the unit, push
in and turn the knob to the unlock position and lift the unit out.
2. If it is necessary to change the angle of the bracket for proper
viewing angle, loosen the upper bracket knob and rotate the
GPSMAP 195 up or down, then re-tighten the knob.
APPENDIX A
92
ACCESSORIES & INSTALLATION (cont.)
gps 195 manual C 7/1/99 4:49 PM Page 92
