Mounting the GPSMAP unit
The GARMIN GPSMAP’s fully gasketed and sealed case is suitable for mount-
ing in exposed locations or at the nav station. The unit comes with a gimbal
bracket that can be used for surface or overhead mounting. When choosing a
location for the display unit, make sure you consider the following conditions:
• There should be at least 3.25” (8.25 cm) clearance behind the case to
allow connection of the antenna and power/data cables.
• Provide adequate clearance for the G-chart cartridge cover to swing
open freely. You may swivel the unit to get a firm grip on the cartridge.
• The mounting surface should be heavy enough to support the unit and
protect it from excessive vibration and shock.
• The GPSMAP 215 screen will provide crisp contrast in most lighting
conditions, even in full sunlight. Because of the technology used in TFT
screens, the GPSMAP 225 performs best in shaded conditions, protect-
ed from direct sunlight.
To install the GPSMAP unit:
1. Place the mounting bracket in the desired location.
2. Mark and drill the four mounting holes for the fasteners you are using.
3. Fasten the bracket to the surface using the appropriate fasteners.
4. Insert the GPSMAP into the mounting bracket. The bracket is designed for a
tight fit to provide additional support when swiveling the unit.
5. Screw the two mounting knobs through the bracket and into the display case.
6. Connect the power/data and antenna cables to the back of the unit, making
sure the locking rings are fully tightened on both connectors.
WARNING!
The temperature range for GPSMAP units
is from -4 to +158ºF (-20- 70ºC). Extended
exposure to temperatures exceeding this range
(in storage or operating conditions) may cause
failure of the LCD screen. This type of failure
and related consequences ARE NOT covered
by the manufacturer’s warranty.
68
SECTION
A
APPENDIX
Installation
215225manb.qxd 4/27/00 9:22 AM Page 68
