Selecting an Approach
CAUTION:
The approaches provided in the Jeppesen database
are for monitoring purposes only. The GPSMAP 396 is not an
IFR-approved instrument and should not be used as a primary
source of navigation guidance in instrument conditions.
When you select an approach, it replaces the destination airport with
the sequence of waypoints for the selected approach. Keep in mind
that the airport must have a published approach (GPS, RNAV, VOR,
NDB, localizer, or ILS) and only the final course segment (usually
from final approach fix to missed approach point) of the published
approach is available in the GPSMAP 396.
NOTE:
When using a route, the selected approach for the
destination airport overrides your current route. The original
route is saved in the Route tab.
You can select an approach several ways:
• Press the
Direct To
and press
MENU
on the Go To Page,
as described in the steps to the right.
• From the Active Go To (or Active Route) Page, press
MENU
.
• From the Airport Details Page, select the Approach tab.
To select an approach for the destination airport:
1. Press the
Direct To
to show the Go To Page. Select the
destination you want to travel to.
2. Press
MENU
to open the options menu. Highlight
Select
Approach
, and press
ENTER
.
3. Use the
ROCKER
to select the approach from the window,
and press
ENTER
.
Selecting an Approach
4. A Vectors? window appears. See the following page for more
information on vectors. Use the
ROCKER
to select
Yes
or
No
, and press
ENTER
. The GPSMAP 396 removes the
destination airport from the Go To and replaces it with the
approach waypoints.
22
GPSMAP 396 Pilot’s Guide
B
ASIC
O
PERATION
IN
A
VIATION
M
ODE
>
S
ELECTING
AN
A
PPROACH
