86
GPSMAP
®
6000/7000 Series Owner’s Manual
Radar
When using a GMR xHD radar, the last gain and clutter settings configured for use in any radar mode are
applied to the Radar Overlay automatically. For example, if the gain for the Harbor mode is set to 50%, the
gain for the Radar Overlay is set to 50% automatically. Later, if the gain for the Offshore mode is set to 40%,
the gain for the Radar Overlay is set to 40% automatically.
Default Gain and Clutter Settings
Setting
Default Value
Instructions
Gain
Auto
See “Automatically Adjusting Gain on the Radar Screen”
)�
Sea Clutter
Calm
See “Restoring the Default Sea Clutter Setting” (
)�
Rain Clutter
Off
See “Restoring the Default Rain Clutter Setting” (
)�
FTC
Off
See “Restoring the Default FTC Setting” (
)�
Crosstalk
On
See Adjusting Crosstalk Clutter on the Radar Screen” (
)�
Automatically Adjusting Gain on the Radar Screen
Auto is the default value for the gain setting. The automatic gain setting for each radar mode is optimized for
that mode, and may differ from the automatic gain setting used for another mode.
Note
: Depending upon the radar in use, the gain setting configured for use in one radar mode may or may
not be applied to other radar modes or to the Radar Overlay (
1. From the Home screen, select
Radar
.
2. Select
Cruising
,
Harbor
,
offshore
,
Dual Range
or
Sentry
mode.
3. Complete an action:
• Select
Menu
>
Gain
>
Auto
for Cruising, Harbor, Offshore, or Sentry mode.
• Configure the setting for the short-range screen in Dual Range mode. Select
>
Menu
>
Gain
>
Auto
for the GPSMAP 6000 series. Select
Left
>
Gain
>
Auto
for the GPSMAP 7000 series.
• Configure the setting for the long-range screen in Dual Range mode. Select
>
Menu
>
Gain
>
Auto
for the GPSMAP 6000 series. Select
Right
>
Gain
>
Auto
for the GPSMAP 7000 series.
The chartplotter sets the gain automatically once, based on average conditions, the range of the radar
signal, and the selected radar mode. The chartplotter does not readjust the gain automatically in response to
changing conditions.
Manually Adjusting Gain on the Radar Screen
For optimal radar performance that accounts for actual conditions, you can manually adjust the gain.
Note
: Depending upon the radar in use, the gain setting configured for use in one radar mode may or may
not be applied to other radar modes or to the Radar Overlay (
1. From the Home screen, select
Radar
.
2. Select
Cruising
,
Harbor
,
offshore
,
Dual Range
or
Sentry
mode.
Summary of Contents for GPSMAP 6008
