nüvi 800 Series Owner’s Manual
Getting Started
3. Clean and dry your windshield with
a lint-free cloth. Remove the clear
plastic from the suction cup, and
clean it with a lint-free cloth. Place
the suction cup on the windshield.
4. Flip the lever back, toward the
windshield.
5. Fit the bottom of your nüvi into the
cradle.
6. Tilt the nüvi back until it snaps into
place.
7. Plug the other end of the vehicle
power cable into a power outlet in
your vehicle. Your unit should turn on
automatically if it is plugged in and
your vehicle is running.
8. If you are using a traffic receiver in
Europe, secure the traffic receiver
antenna to the windshield using the
suction cups.
Step 3: Configure the
nüvi
To turn on your nüvi, slide the
Power
key to the left. Follow the on-screen
instructions.
Step 4: Acquire Satellites
Go outdoors to an open area, out of
garages, and away from tall buildings.
Stop your vehicle, and turn on the nüvi.
Acquiring satellite signals can take a few
minutes.
The
bars indicate GPS satellite
strength. When one bar is green, the nüvi
has acquired satellite signals. Now you
can select a destination and navigate to
it. For more information about GPS, see
.
