Selecting a Preset
1 From an applicable media screen, select Presets.
2 Select a preset from the list.
3 Select Tune to Channel.
Removing a Preset
1 From an applicable media screen, select Presets.
2 Select a preset from the list.
3 Select Remove Current Channel.
DAB Playback
When you connect a compatible Digital Audio Broadcasting (DAB) module and antenna, such as the Fusion
®
MS-DAB100A to a compatible stereo, you can tune in to and play DAB stations
To use the DAB source, you must be in a region in which DAB is available, and select the tuner region (
the DAB Tuner Region, page 132
).
Setting the DAB Tuner Region
You must select the region you are in to receive DAB stations properly.
1 From the media screen, select Menu > Installation > Tuner Region.
2 Select the region you are in.
Scanning for DAB Stations
NOTE: Because DAB signals are broadcast in select countries only, you must set the tuner region to a location
where DAB signals are broadcast.
1 Select the DAB source.
2 Select Scan to scan for available DAB stations.
When scanning is complete, the first available station in the first ensemble found begins playing.
NOTE: After the first scan is complete, you can select Scan again to re-scan for DAB stations. When the re-
scan is complete, the system starts playing the first station in the ensemble you were listening to when you
started the re-scan.
Changing DAB Stations
1 Select the DAB source.
2 If necessary, select Scan to scan for local DAB stations.
3 Select
or
to change the station.
When you reach the end of the current ensemble, the stereo automatically changes to the first available
station in the next ensemble.
TIP: You can hold
or
to change the ensemble.
Selecting a DAB Station from a List
1 From the DAB media screen, select Browse > Stations.
2 Select a station from the list.
Selecting a DAB Station from a Category
1 From the DAB media screen, select Browse > Categories.
2 Select a category from the list.
3 Select a station from the list.
132
Media Player
