Setting Weather Alarms
Before you can set weather alarms, you must have a compatible chartplotter connected to a weather device,
such as a GXM device, and have a valid weather subscription.
1 Select
> Alarms > Weather.
2 Turn on alarms for specific weather events.
Setting the Fuel Alarm
CAUTION
The Beeper setting must be turned on to make alarms audible (
Sounds and Display Settings, page 171
). Failure
to set audible alarms could lead to injury or property damage.
Before you can set a fuel level alarm, you must connect a compatible fuel flow sensor to the chartplotter.
You can set an alarm to sound when the total amount of remaining onboard fuel reaches the level you specify.
1 Select
> Alarms > Fuel > Total Fuel Onboard > On.
2 Enter the remaining amount of fuel that triggers the alarm, and select Done.
My Vessel Settings
NOTE: Some settings and options require additional charts or hardware.
Select
> My Vessel.
Transducers: Shows all transducers on the network, allows you to change transducers, and allows you to view
diagnostic information (
Selecting the Transducer Type, page 78
).
Depth and Anchoring: Allows you to enter information about the keel (
Setting the Keel Offset, page 64
) and the
anchor.
The Anchor Height value is the height of the anchor above the waterline. The Anchor Scope value is the ratio
of the length of anchor rode in use to the vertical distance from the bow of the vessel to the bottom of the
water. These anchor settings are used to calculate the Target Anchor Rode date field.
Temp. Offset: Allows you to set an offset value to compensate for the water temperature reading from a
connected water-temperature sensor or a temperature-capable transducer (
).
Calibrate Water Speed: Calibrates the speed-sensing transducer or sensor (
Calibrating a Water-Speed Device,
).
Fuel: Sets the combined fuel capacity and fuel remaining in the fuel tanks on your vessel (
).
Vessel Type: Enables some chartplotter features based on the boat type.
Switching: Sets the digital switching circuits, such as SeaStar
®
and CZone
™
devices.
Polar Table: Enables polar table data, when the vessel type is not a powerboat.
System Profiles: Allows you to save your system profile to a memory card and import system profile settings
from a memory card. This can be helpful for charter or fleet vessels, and for sharing your setup information
with a friend.
Hull ID Number: Allows you to enter the Hull Identification Number (HIN).The HIN might be permanently affixed
to the upper starboard side of the transom or outboard side.
Optimus Steering: Allows you to adjust the Optimus steering parameters.
Device Configuration
179
Summary of Contents for GPSMAP1222
Page 1: ...GPSMAP 10X2 12X2SERIES Owner sManual...
Page 14: ......
Page 213: ......
Page 214: ...support garmin com GUID C3CEA164 A1CB 4B15 92F2 5C04944CC6F3 v21 January 2024...