6-11
190-01004-03 Rev. P
GTN 625/635/650 Pilot’s Guide
Proc
6. If desired, touch the
Channel/ID
key, then use the numeric
keypad to select the channel number, and then touch the
Enter
key. The Channel and ID are typically loaded automatically if
they are present.
NOTE:
As an alternate means of loading an approach, the Channel ID key
allows you to select the channel ID for a SBAS approach for the current
destination. The channel ID for the SBAS approach is available from an
approved approach chart. If duplicate numbers are available for a channel,
a list will be available where you may select the desired approach.
7. Touch the
Preview
key.
Sequence List
for Selected
Transition
Approach
Diagram
Touch to Activate
Approach
Unselected
Transition
Selected
Transition
Figure 6-20 Selected Approach Preview
8. Touch the
Load Approach
key. The Active Flight Plan page
will be displayed. The approach waypoints are placed at the
end of the flight plan and the unit will automatically sequence
to them after the en route waypoints.
Summary of Contents for GTN 625
Page 608: ...This page intentionally left blank ...
Page 609: ......
Page 610: ...190 01004 03 Rev P ...
