System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
190-01007-A1
Page A-12
Rev. 5
A.6 Equipment Interfaced to the GTN 6XX/7XX
The purpose of Table A-3 and Table A-4 is to document the equipment that is interfaced to the GTN(s).
Use the following guidance when filling out this table:
Installed?
: Check “Yes” if the equipment is installed in the aircraft and interfaced to the GTN. If
the equipment is not installed in the aircraft, check “No.” If the equipment is installed in the
aircraft but not interfaced to the GTN, check “No”.
Model(s)
: Write in the model number or numbers of the equipment that is interfaced to the GTN.
Interface(s)
: Write in the type of interface used to connect to the GTN.
GTN Port Numbers
: When applicable, write in the GTN port number or numbers used for the
interface. This column is generally applicable only to serial ports such as RS-232 and ARINC 429.
Covered by GTN STC Installation Manual?
: See Section 3 of this document. Check “Yes” if the
equipment is listed in Appendix C of the GTN 6XX/7XX AML STC Installation Manual. Check
“No” if the equipment is not listed in Appendix C of the GTN 6XX/7XX AML STC Installation
Manual.
NOTE
This information is optional and is not required to be completed or maintained with the
aircraft records.
