System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
190-01007-A1
Page 6-10
Rev. 5
6.6 Configuration Module (P1001 Only)
GTN P1001 connector assemblies serve as the housing for a configuration module. This section lists
configuration module assemblies.
Table 6-2. Configuration Module Wire Color Reference Chart
NOTE
The pin contacts supplied with the GTN configuration module are specifically made to
accommodate 28 AWG wire. The crimp tool should have the indenter set to the correct
setting when crimping these contacts to the configuration module harness.
Configuration modules are located within the GTN harness connector backshell (Item 6, Figure 6-4).
There are two configuration module kits that have been approved for use with the GTNs.
The 011-00979-00 configuration module kit has a spacer (Figure 6-4), while the 011-00979-03
configuration module kit does not (Figure 6-3). The 011-00979-03 configuration module kit is
recommended for all replacements. The instructions for removal/replacement of a configuration module
apply equally to either P/N. Unless otherwise noted, refer to the corresponding backshell assembly
drawing when performing the following removal and reinstallation steps.
Color
Function
P1001 Contact
Red
Vcc
65
Black
Ground
64
Yellow
Data
62
White
Clock
63
