190-01007-C1
GTN Xi Part 23 AML STC Maintenance Manual
Rev. 1
Page 6-13
Table 6-3 Configuration Module Kit P/N 011-00979-03 (P1001)
Figure 6-6 Backshell Assembly (Potted Configuration Module)
Removal
1. Disconnect the connector (
5
) from the GTN Xi backplate assembly.
2. Remove two screws (
8
) from cover (
7
) and remove cover.
3. Unplug the connector from the configuration module (
1
).
4. Remove the configuration module from the backshell (
6
).
Re-installation
1. Inspect the connector for damaged pins (
4
) or wires (
3
).
2. Place the configuration module (
1
) in position.
3. Insert connector into the configuration module (
1
).
4. Place the cover (
7
) back on the connector and re-install screws (
8
).
Reference
Description
Garmin P/N
1
Configuration Module, PCB Board Assembly w/EEPROM
011-02178-00
3
4-Conductor Harness
325-00122-00
4
Pin Contact, Crimp, #22D
336-00021-00
