1
Setting Up your iQue 3200
GPS Antenna in the On Position
Pull the antenna out and rotate
up to the On position. Be sure
the antenna is parallel with the
horizon.
NOTE:
This antenna is designed to
best receive satellite signals when it
is aligned parallel with the horizon.
If the antenna is positioned verti-
cally, the iQue’s ability to receive
satellites may be dramatically
reduced.
Setting up and Customizing your iQue 3200
You may customize your iQue 3200 to fit your needs, such as assign-
ing applications to open with certain buttons on the unit.
Initializing the GPS Receiver
The GPS Receiver must be turned on and initialized (given an op-
portunity to determine its location) before you can begin using it for
navigation. When the unit initializes for the first time it may take as
long as 15 minutes. Any time you have traveled more than 600 miles
with the GPS receiver turned off, the iQue handheld must again find its
location by re-initializing. The initialization time can be shortened by
using the map to point to the general area are currently located (see the
“Establishing a New Location” section of this guide).
To turn the receiver on and initialize it:
1. Rotate the antenna located on the back of the iQue 3200 so it is
parallel with the horizon. This is the “On” position.
2. Have a clear view of the sky to receive satellite signals. Satellite
signals cannot pass through solid materials (except glass) or dense
overhead tree cover.
Customizing the iQue 3200’s Units Settings
1. From the Applications Launcher screen, tap the
Prefs
icon.
2. Tap the symbol below the Preferences title to display the pick list
of options. Then tap
Units
to display the Units customizing page.
3. Select the desired units settings (such as
Statute
or
Metric
) for
distance, speed, elevation, depth, and direction as needed.
Overview
