3 Place the base between the handle and the top pole , and screw them together.
4 Determine how many of the three middle pole segments you need to use, based on the thickness of the ice.
TIP: The top of the transducer must be below the bottom of the ice for best performance.
5 Screw together the needed segments, with the shortest segment on the bottom of the pole.
6 Use the included hex wrench to attach the transducer to the bracket with the shoulder screw , flat
washer
, and rubber washer
.
NOTE: You must fully tighten the shoulder screw to secure the transducer to the bracket. The recommended
torque applied to the shoulder screw is 2.5 lb-ft. (3.4 N-m).
7 Using the hex wrench and the M6 screws , attach the two halves of the bracket around the pole.
8 After mounting the transducer on the pole, use the hook and loop straps to secure the transducer cable to
the pole.
3
