nüvi 465 owner’s manual
Getting Started
Setting Up Your nüvi
Attaching the Adhesive Disk
and the Mounting Base to Your
Dashboard
Note:
The permanent adhesive disk
is extremely difficult to remove.
1. Clean and dry the area where you
want to place the mounting base.
2. Select the adhesive disk you want
to use, and remove one side of the
backing.
Temporary Disk
Permanent Disk
3. Place the adhesive disk on the bottom
of the mounting base, and remove the
other side of the backing.
4. Place the mounting base so that the
locking lever is facing you. Position
the base on the cleaned area. Apply
pressure to adhere the base to the
dashboard.
5. Snap the cradle onto the mounting
arm.
Cradle
Mounting
arm
6. Slide the mounting arm with cradle
attached into the mounting base.
Mounting
arm with
cradle
Mounting
base
Locking
lever
7. Slide the locking lever into the locked
position.