4
zūmo 400/450 Owner’s Manual
G
ettinG
S
tarted
A) To install the U-bolt and handlebar
base:
1. Place the U-bolt around the handlebar,
and thread the ends through the handlebar
base.
2. Tighten the nuts to secure the base. Do
not overtighten.
notE:
The recommended torque
is 50in-lb (5.7 N-m)
.
Do not exceed
maximum torque of 80in-lb (9 N-m).
B) To install the handlebar base to the clutch/brake clamp bracket:
notE:
Both 1/4” standard and M6 bolts are included. Match the size of the
factory bolts on your clutch/brake clamp bracket.
1. Remove the two factory bolts
on your clutch/brake clamp
bracket.
2. Thread the new bolts through
the handlebar base, spacers,
and clamp bracket.
3. Tighten the bolts to secure the
base.
Handlebar
base
Handlebar
U-bolt
Clutch/brake
clamp bracket
Handlebar
base
Spacers
