6
Grip the battery connector wires close to the connector, and
pull the connector perpendicular to the circuit board to
disconnect the battery connector from the device.
7
Remove the battery.
The battery fits tightly. It may be necessary to pry the battery
out of the back plate using a non-sharp, non-metal object.
8
Install the new battery into the front enclosure with the label
side of the battery facing up, and the lead edge of the battery
placed under the contact ledge of the device.
9
Replace the battery plate, and replace and tighten the two
screws.
10
Verify the gasket is not damaged and is completely seated in
the groove.
11
With the new battery, connect the battery connector to the
device.
When properly installed, the connector plug snaps into the
port.
12
Replace the front plate, and replace and tighten the six
screws to secure the front plate.
13
Replace the screw securing the VHF antenna to the back
plate.
14
Replace the cover over the VHF antenna.
15
Replace the three screws on the cover.
16
Verify the gasket is not sticking out of the device.
3
