For questions concerning the license application, contact the
FCC at 1-888-Call-FCC (1-888-225-5322).
No license is required to operate on GMRS channels in Canada.
However, GMRS repeater channels are not approved for use by
the Canadian government.
For use in countries outside of the U.S. and Canada, please
check with that government for any restrictions of FRS or GMRS
use.
Viewing Device Information
You can view the unit ID, software version, regulatory
information, and license agreement.
From the home screen, select
Setup
>
About
.
Troubleshooting
The battery gauge does not seem accurate
1
Allow the device to fully discharge.
2
Fully charge the device without interrupting the charge cycle.
My device is not acquiring satellite signals
• Verify the GPS simulator is turned off (
).
• Take your device out of parking garages and away from tall
buildings and trees.
• Remain stationary for several minutes.
My device does not go into mass storage
mode automatically
If your device is connected to the computer but does not go into
mass storage mode automatically, you might have loaded a
corrupt file.
1
Disconnect the device from your computer.
2
Turn off the device.
3
Hold while you connect the device to your computer.
4
Continue holding for 30 seconds or until the device goes
into mass storage mode.
I need to reset all settings back to factory
default values
Select
Setup
>
Reset
>
Reset All Settings
.
Appendix
Data Fields
Some data fields require you to be navigating or require ANT+
®
accessories to display data.
Accuracy of GPS
: The margin of error for your exact location.
For example, your GPS location is accurate to /- 12 ft.
(3.65 m).
Battery Level
: The remaining battery power.
Bearing
: The direction from your current location to a
destination. You must be navigating for this data to appear.
Course
: The direction from your starting location to a
destination. Course can be viewed as a planned or set route.
You must be navigating for this data to appear.
Distance To Dest.
: The remaining distance to the final
destination. You must be navigating for this data to appear.
Distance To Next
: The remaining distance to the next waypoint
on the route. You must be navigating for this data to appear.
Elevation
: The altitude of your current location above or below
sea level.
ETA at Destination
: The estimated time of day when you will
reach the final destination (adjusted to the local time of the
destination). You must be navigating for this data to appear.
ETA at Next
: The estimated time of day when you will reach the
next waypoint on the route (adjusted to the local time of the
waypoint). You must be navigating for this data to appear.
Glide Ratio
: The ratio of horizontal distance traveled to the
change in vertical distance.
Glide Ratio to Dest.
: The glide ratio required to descend from
your current position to the destination elevation. You must
be navigating for this data to appear.
GPS Signal Strength
: The strength of the GPS satellite signal.
Heading
: The direction you are moving.
Location (lat/lon)
: The current position in latitude and longitude
regardless of the selected position format setting.
Location (selected)
: The current position using the selected
position format setting.
Odometer
: A running tally of distance traveled for all trips. This
total does not clear when resetting the trip data.
Off Course
: The distance to the left or right by which you have
strayed from the original path of travel. You must be
navigating for this data to appear.
Pointer
: An arrow points in the direction of the next waypoint or
turn. You must be navigating for this data to appear.
Speed
: The current rate of travel.
Speed - Maximum
: The highest speed reached since the last
reset.
Speed - Moving Avg.
: The average speed while moving since
the last reset.
Speed - Overall Avg.
: The average speed while moving and
stopped since the last reset.
Sunrise
: The time of sunrise based on your GPS position.
Sunset
: The time of sunset based on your GPS position.
Time of Day
: The current time of day based on your current
location and time settings (format, time zone, daylight saving
time).
Time to Destination
: The estimated time remaining before you
reach the destination. You must be navigating for this data to
appear.
Time to Next
: The estimated time remaining before you reach
the next waypoint in the route. You must be navigating for
this data to appear.
To Course
: The direction in which you must move to get back
on the route. You must be navigating for this data to appear.
Trip Odometer
: A running tally of the distance traveled since
the last reset.
Trip Time - Moving
: A running tally of the time spent moving
since the last reset.
Trip Time - Stopped
: A running tally of the time spent not
moving since the last reset.
Trip Time - Total
: A running tally of the total time spent moving
and not moving since the last reset.
Turn
: The angle of difference (in degrees) between the bearing
to your destination and your current course. L means turn
left. R means turn right. You must be navigating for this data
to appear.
Velocity Made Good
: The speed at which you are closing on a
destination along a route. You must be navigating for this
data to appear.
Vertical Speed
: The rate of ascent or descent over time.
Vertical Speed to Dest.
: The rate of ascent or descent to a
predetermined altitude. You must be navigating for this data
to appear.
Troubleshooting
13
