Turning On Battery Save Mode
You can use battery save mode to prolong the battery life.
From the app drawer, select Setup > Display > Battery Save > On.
In battery save mode, the screen shuts off when the backlight times out. You can select to turn on the
screen.
Acquiring GPS Signals
When you turn on your navigation device, the GPS receiver must collect satellite data and establish the current
location. The time required to acquire satellite signals varies based on several factors, including how far you are
from the location where you last used your navigation device, whether you have a clear view of the sky, and how
long it has been since you last used your navigation device. The first time you turn on your navigation device, it
may take several minutes to acquire satellite signals.
1 Turn on the device.
2 Wait while the device locates satellites.
3 If necessary, go to an open area, away from tall buildings and trees.
in the status bar indicates the satellite signal strength. When at least half the bars are filled, the device is
ready for navigation.
Radio
In the United States, this device uses General Mobile Radio Service (GMRS) for two-way communication with
other compatible radio devices.
In Canada, this device uses Family Radio Service (FRS) and General Mobile Radio Service (GMRS) for two-way
communication with other compatible radio devices.
In Australia, this device uses UHF Citizen Band Radio Service (UHF CBRS), and in New Zealand, this device uses
UHF Personal Radio Service (PRS) for two-way communication with other compatible radio devices.
When communicating with other Rino radio devices, additional features are available.
Transmitting
To communicate with other Rino users or compatible radio devices, you must be on the same channel and code
(
).
1 Hold PTT.
2 Speak into the front of the device.
3 After you are finished speaking, release PTT.
The radio transmits your position information. You cannot hear incoming transmissions until your
transmission is complete. A roger tone sounds on your radio and on the radios receiving your transmission
to confirm that the transmission is complete.
NOTE: You can change or disable the roger tone (
Setting the Device Tones, page 34
).
The Radio App
Using the radio app, you can view information about the radio, control the radio channel and squelch codes, and
customize the radio features.
Icons along the top of the radio page provide useful information about the radio.
: Indicates the activity status of the radio. When an arrow is pointing at the radio, the radio is receiving a
transmission. When an arrow is pointing away from the radio, the radio is transmitting.
: The radio is ready to transmit position information (
Peer-to-Peer Positioning, page 10
).
: Weather alerts are enabled (
).
: The radio is muted (
Adjusting the Radio Volume, page 8
).
Radio
7
Summary of Contents for Rino 750t
Page 1: ...Rino 750 750t 755t Owner s Manual...
Page 6: ......
Page 63: ......
Page 64: ...support garmin com GUID 35474A49 ADDB 451D A6DA AA003B2A4ACC v7 April 2023...
