52
Road Tech
™
zūmo 665 Owner’s Manual
Appendix
Changing the Fuse
CaUTIOn
When replacing the fuse, do not lose
any of the small pieces, and ensure
they are put back in the proper place.
If your unit does not charge in your
vehicle, you may need to replace
the fuse located at the tip of the
automotive adapter.
1. Unscrew the black, round end
piece, and remove it.
2. Remove the fuse (glass and silver
cylinder), and replace with a 3A
fast‑blow fuse.
3. Ensure that the
silver tip is placed
in the black end
piece. Screw on
the black end
piece.
about gPS Satellite
Signals
Your zūmo must acquire GPS (Global
Positioning System) satellite signals
to navigate. If you are indoors, near
tall buildings or trees, or in a parking
garage, your zūmo cannot acquire
satellites. Go outside to an area free
from tall obstructions to use your
zūmo.
When your zūmo has acquired satellite
signals, the signal strength bars on the
Menu page are green
. When it
loses satellite signals, the bars turn red
or clear
.
For more information about GPS, go
to
.
Mounting on Your
Dashboard
Notice
The
permanent
mounting adhesive is
extremely difficult to remove after it is
installed.
Use the enclosed mounting disk to
mount your unit to the dashboard and
comply with certain state regulations.
1. Clean and dry the dashboard
where you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover
from the top of the disk.
5. Place the suction cup mount on
top of the disk. Flip the lever down
(toward the disk).
End
pece
Slver tp
Fuse
End
pece
Slver tp
Fuse
Summary of Contents for Road Tech Zumo 665
Page 1: ...ZŪMO 665owner s manual TM ...