Getting Pulse Oximeter Readings
You can manually begin a pulse oximeter reading from the pulse oximeter glance. The accuracy of the pulse
oximeter reading can vary based on your blood flow, the watch placement on your wrist, and your stillness.
NOTE: You may need to add the pulse oximeter glance to the glance loop (
).
1 While you are sitting or inactive, swipe up or down to view the pulse oximeter glance.
2 Select the glance to begin the reading.
3 Hold the arm wearing the watch at heart level while the watch reads your blood oxygen saturation.
4 Keep still.
The watch displays your oxygen saturation as a percentage, and a graph of your pulse oximeter readings and
heart rate values for the last 24 hours.
Changing the Pulse Oximeter Tracking Mode
1 Hold .
2 Select Settings > Sensors & Accessories > Pulse Ox > Tracking Mode.
3 Select an option:
• To turn on measurements while you are inactive during the day, select All Day.
NOTE: Turning on pulse oximeter tracking decreases battery life.
• To turn on continuous measurements while you sleep, select During Sleep.
NOTE: Unusual sleep positions can cause abnormally low sleep-time SpO2 readings.
• To turn off automatic measurements, select On Demand.
Tips for Erratic Pulse Oximeter Data
If the pulse oximeter data is erratic or does not appear, you can try these tips.
• Remain motionless while the watch reads your blood oxygen saturation.
• Wear the watch above your wrist bone. The watch should be snug but comfortable.
• Hold the arm wearing the watch at heart level while the watch reads your blood oxygen saturation.
• Use a silicone or nylon band.
• Clean and dry your arm before putting on the watch.
• Avoid wearing sunscreen, lotion, and insect repellent under the watch.
• Avoid scratching the optical sensor on the back of the watch.
• Rinse the watch with fresh water after each workout.
Navigation
You can use the GPS navigation features on your watch to save locations, navigate to locations, and find your
way home.
46
Navigation