zūmo 600 Series Owner’s Manual
Getting Started
Mounting Your zūmo on a
Motorcycle
Warning:
Incorrectly wiring the power
cable with bare wire leads can result in
damage to the vehicle or the battery and
can cause bodily injury. Garmin strongly
recommends having an experienced
installer with the proper knowledge of
electrical systems install the unit.
Step 1: Connecting Power to the
Mount
Select a suitable and secure location to
mount the zūmo on your motorcycle based
on available power sources and safe cable
routing.
Cradle
Headphone/audio out jack (3. mm)
Microphone jack (2. mm)
Mini-USB connector
(for traffic receiver)
Bare wires with
inline fuse for
power connection
Power cable
Step 2: Installing the Handlebar
Base
The zūmo includes parts for two handlebar
installation solutions. Custom mounts can
require additional hardware (
www.ram
-mount.com
).
A) To install the U-bolt and handlebar
base:
1. Place the U‑bolt around the handlebar,
and thread the ends through the
handlebar base.
2. Tighten the nuts to secure the base. Do
not overtighten.
noTe:
The recommended torque is 50
lbf-in. Do not exceed torque of 80 lbf-in.
Handlebar
base
Handlebar
U-bolt
B) To install the handlebar base to the
clutch/brake clamp bracket:
noTe:
Both 1/4” standard and M6 bolts
are included. Match the size of the factory
bolts on your clutch/brake clamp bracket.
1. Remove the two factory bolts on your
clutch/brake clamp bracket.
2. Thread the new bolts through the
handlebar base, spacers, and clamp
bracket.
3. Tighten the bolts to secure the base.
Clutch/brake
clamp bracket
Handlebar
base
Spacers
Summary of Contents for Zumo 660
Page 1: ...z mo 600 series owner s manual for use with the z mo 660...
Page 6: ......
Page 51: ......