PD-5 Operator Manual
Page 11
WARNING
Changes or modifications not expressly approved by the party responsible for compliance to Part 15 of the FCC
Rules could void the user’s authority to operate the equipment.
To disconnect main power from this system,
disconnect the input power plug from the
wall.
“Destroy” cycle. Starts the media crushing
cycle.
Do not cover chassis ventilation slots or block
enclosure openings.
Refer to maintenance manual
Disconnect main power and unplug unit from
the wall before installing or removing device
or servicing equipment.
No operator-serviceable parts inside unit.
Maintenance to be done only by trained
personnel.
Do not operate if the door is damaged or
missing.
For continued protection against risk of fire,
replace only with the same type and rating of
fuse.
A non-shielded power cord may be used to
connect AC power to the system. Use only
power cords approved by Garner Products
Inc.
Check input voltage before plug in.
Crush Hazard. Keep safety door closed
during operation.
Equipment weighs more than 40 lbs (18kg),
two person lift.
Power, On / Off
FCC NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operations.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
