12
13
EN
EN
Activating/Deactivating RFID
Activating/Deactivating RFID
(figure 5)
Activating RFID reader
To activate the RFID reader, check the box labelled ‘Request RFID when connecting’ and
click ‘Save’. Note the checkbox is only visible when a RFID reader is installed.
Deactivating RFID reader
To deactivate the RFID reader, un-check the box labelled ‘Request RFID when connecting’
and click ‘Save’.
GLB mode ON=Master: OFF=Slave
SW1
(figure 4)
Activate RFID reader on individual GLB Wallbox
To activate RFID reader on a GLB Walbox that is stand alone (not connected with other
GLB Wallboxes), it is important to make the charger a master wallbox.
To verify that the master wallbox is defined as master, ensure the SW1 switch (DIP 5) is
set to ‘ON’.
Note: It is only possible to have one Master GLB in a system when connecting GLB
Wallboxes with the datalink bus.
