29
EN
End user instrucion /
Charging electric vehicles
1. Connect the wallbox to the vehicle using the cable.
2. When charging starts, solid blue light indicates charging in progress.
3. Stop charging. As a rule, the wallbox socket and vehicle inlet locks the cable. As
a result, charging must be stopped from the vehicle before the cable is removed.
Terminate charging according to the vehicles instruction manual, removing connector
from car before removing connector at charger end.
4. After terminated charging, make sure cable is suspended.
If your wallbox is equipped with a socket, it is important to use the right type of cable. For
example, to charge at 32A, a 32A cable is required.
The status of the wallbox can be obtained from the colour of the Indication
light (D):
• Solid green light: charging can starts.
• Solid blue light: device connected to vehicle, charging in progress. (The blue light
flashes three times when charging starts)
• Red/yellow light: fault. Refer to section on Troubleshooting.
Charging electric vehicles
Summary of Contents for Wallbox GHL
