Garrett AT Max, Manual

32 Garrett Metal Detectors

AT Max

™ 

33

Z-Lynk Wireless Operation

Z-Lynk Wireless—

The 

AT Max

 features a built-in Z-Lynk wireless 

transmitter which can be used with the Garrett MS-3 headphones. 
It will also connect to most any other headphones using a 
separate Z-Lynk receiver.
  A Z-Lynk Wireless headphone icon 

(see illustration)

 on the LCD 

indicates the current status of your wireless connection. A steady 
icon indicates the detector is paired with an operating Z-Lynk 
receiver that is within range. A flashing icon indicates that the 
detector is searching for a receiver. Absence of the icon indicates 
that the 

AT Max's

 wireless transmitter is switched off.

Pairing:

 To pair with a new set of headphones/receiver, simply 

switch the headphone/receiver on, hold within 2 feet (0.6 meters) 
of the 

AT Max

, and then press and release the Z-Lynk buttons 

(IRON AUDIO and FREQ) at the same time. Make sure the wireless 
icon on the 

AT Max

 is flashing or absent when you press the 

buttons.

  Once paired, if the headphone/receiver is switched off or moved 
out of range, the 

AT Max

 will search and attempt to reconnect to  

the receiver for 30 seconds, indicated by a flashing icon. If the 
connection is not reestablished during this time, the 

AT Max

 will 

switch off its wireless transmitter. It will be necessary to switch the 

AT Max

 off and then on again to initiate a new 30-second search.  

  To un-pair (forget) a set of headphones, simply press the Z-Lynk 
buttons simultaneously while the wireless icon on the 

AT Max

 is 

on steady.

Z-Lynk Wireless for Water Hunting:

 The 

AT Max

 can be 

operated wirelessly for shallow wading, but wireless operation 
is not possible when the detector is fully submerged. The Z-Lynk 
MS-3 Wireless Headphones should never be submerged. When 
the 

AT Max

 will be fully submerged, waterproof headphones (sold 

separately) are required. Refer to "Underwater Operation" section 
of this manual for more information. 

PAIRING

: 

Switch on headphones and hold within 2 feet of 

AT Max

, then press and 

release Z-Lynk buttons (IRON AUDIO and FREQ) simultaneously.

A solid red LED on the MS-3 headphones and 
this steady Z-Lynk Wireless icon on the LCD 
indicates successful pairing.