Magnum P80F & P80C Personal Switches Installation and User Guide (07/03)
14
www GarrettCom com
.
.
3.0 INSTALLATION
This chapter provides instructions for installing Magnum P80-series units.
3.1
Locating Magnum P80F & P80C 10/00Mb Personal Switch
The location of a Magnum P80F & P80C Personal Switch is dependent on the
physical layout of the network. Typically the switch is located in a workplace site. The compact
size of the unit allows it to be conveniently placed in an office, classroom or lab area, and it can
also be either shelf- of wall-mounted (see mounting instructions in 3.1.2 below). Metal wall-
mounting clips are included with the unit.
Locate an AC receptacle that is within six feet (2 meters) of the intended Magnum
P80F & P80C site. The rugged metal case of the Magnum P80F & P80C will normally protect it
from accidental damage in a lab or workplace setting. Maintain an open view of the top surface
to visually monitor the status LEDs.
3.1.1
Table-Top or Shelf Mounting
The Magnum P80F & P80C Personal switch can be easily mounted on a table-top or
any suitable horizontal surface, and has four rubber feet to provide stability without scratching
finished surfaces.
3.1.2
Wall (or vertical surface) mounting
Each Magnum P80-series
Personal Switch is shipped with two metal
mounting brackets (and screws) to allow the
unit to be mounted in nearly any desired
orientation or position. The brackets are attached to the metal Switch case using one of the
Proper attachment of
mounting bracket for wall mounting
Top view
- Magnum P80F with
brackets attached for wall
Magnum P80
Personal Switch
GARRETT
5VDC,
PORTS 1SW 2SW 3 4 5 6 7
Speed
Link/Act
F/H
Power
Error
