M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
158
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : NO
Magnum6K25(stp)##
F
IGURE
86
–
Configuring STP parameters
List of commands in this chapter
his
command lists the switch’s full STP configuration, including ge
s
rt (Enable) or stop (Disable) STP
-65535> -
specifies the port or
switch level priority. When a port(s) are specified the priority is associated with ports a
-
Syntax
c
rt(s)
have to be specified
Syntax
p
ber|list|range> status=<enable|disable>
- specific ports may not need to
participate in STP process. These ports typically would be end-stations. If you
Syntax
timers forward-delay=<4-30> hello=<1-10> age=<6-160>
- change the STP Forward
Delay, Hello timer and Aging timer values
Syntax
show stp <config|ports > -
regardless of whether STP is enabled or disabled (default) t
neral settings and port settings
tp
– STP Configuration mode
Syntax
Syntax
stp <enable|disable>
- Sta
Syntax
priority [port=<number|list|range>] value=<0-255 | 0
nd their value is 0
255. If no ports are specified, then the switch (bridge) priority is specified and its value is 0-65535
ost port=<number|list|range> value=<0-65535>
- cost is specific to a port and the po
ort port=<num
are not sure – let MNS-6K
software make the decisions