M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Syntax
group add ip=<group ip> port=<number|list|range> vlan=<vlanid>
- add ports to a
specific IGMP broadcast
group del ip=<group ip>
- delete ports from a specific IGMP broadcast group
Syntax
show-group
– shows the multicast groups
Syntax
set-port port=< port|list|range> mode=<auto|forward|block>
- set the port
characteristics. Block drops the unregistered multicasts. Forward forwards unregistered multicasts
Syntax
show-port
– display the port characteristics for IGMP
Syntax
show-router
– displays detected IGMP-enabled router ports
Syntax
set-leave <enable|disable>
- enables or disables the switch to immediately process a host sending a
leave message rather that wait for the timer to expire
Syntax
set-querier <enable|disable>
- enables or disables a switch as IGMP querier
Synta
x
set-qi interval=<value>
- The IGMP querier router periodically sends general host-query messages.
These messages are sent to ask for group membership information. This is sent to the all-system multicast
group address, 224.0.0.1. The default value is 125 seconds. The valid range can be from 60 to 127
seconds.
Syntax
set-qri interval=<value> -
The query response interval is the maximum amount of time that can
elapse between when the querier router sends a host-query message and when it receives a response from a
host. The Default value is 10 seconds. The Range can be from 2 to 270 seconds. Restrictions apply to the
maximum value because of an internal calculation that is dependent on the value of the Query Interval
Syntax
mode=<l2|normal> -
Toggle the IGMP mode from L2 to nnormal or IGMP-L2
Chapter 19 - GVRP
Syntax
show gvrp
- shows whether GVRP is disabled, along with the current settings for the maximum
number of VLANs and the current Primary VLAN
Syntax
gvrp <enable|disable
>
- enable or disable GVRP
Syntax
show-vlan
– list all the VLANs (including dynamic VLANs) on the switch
Syntax
set-ports port=<port|list|range> state=<learn|block|disable>
- set the state of the port
to learn, block or disable for GVRP. Note the default state is disable
Syntax
static vlan=<VID>
- convert a dynamic VLAN to a static VLAN
297