M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
command is shown below in Figure 6
Magnum6K25>
enable manager
Password: *******
Magnum6K25#
F
IGURE
7
-
Switching users and privilege levels. Note the prompt changes with the new privilege level.
Operator Privileges
Operator privileges allow views of the current configurations but do not allow changes to
the configuration. A ">" character delimits the Operator-level prompt.
Manager Privileges
Manager privileges allow configuration changes. The changes can be done at the manager
prompt or for global configuration as well as specific configuration. A “#” character
delimits any Manager prompt.
User management
A maximum of five users can be added per switch for MNS-6K and a maximum of
twenty users can be added for MNS-6K-SECURE. Users can be added, deleted or
changed from a manager level account. There can be more than one manager account,
subject to the maximum number of users on the switch.
MNS-6K-SECURE allows a maximum of twenty (20) users. Using MNS-6K-
secure you can also configure access to the switch using capabilities,
described later on in this manual.
Add User
To add a user, use the command “add” as shown below. The user name has to be a unique
name and can be up to 24 characters long. The password is recommended to be at least 8
characters long with a mix of upper case, lower case, numbers and special characters.
Syntax
add user=<name> level=<number>
30
