M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Command
Description
port-mirror <enter>
configure port mirror settings
port-security
configure port security settings
priority [port=<number|list|range>]
value=<0-255 | 0-65535>
specifies the port or switch level priority. When
a port(s) are specified the priority is associated
with ports and their value is 0-255. If no ports
are specified, then the switch (bridge) priority is
specified and its value is 0-65535
priority [port=<number|list|range>]
value=<0-255 | 0-65535>
specifies the port or switch level priority. When
a port(s) are specified the priority is associated
with ports and their value is 0-255. If no ports
are specified, then the switch (bridge) priority is
specified and its value is 0-65535
prtmr <enable|disable>
enable or disable port mirror settings
ps <enable|disable>
enable or disable port security
qos
enter the QoS configuration mode
quickcfg
quick setup for snmpv3 configuration. It
automatically configures a default VACM (view-
based access control model). This allows any
manager station to access the Magnum 6K switch
either via SNMP v1, v2c or v3. The community
name is “public”. This command is only intended
for first time users and values can be changed by
administrators who want more strict access
rate-threshold port=<port|list|range>
rate=<frames/sec>
change the allowed broadcast rate threshold
reauth port=<num|list|range>
[status=<enable|disable>] [period=<10-
86400>]
set values on how the authenticator (Magnum
6K switch) does the re-authentication with the
supplicant or PC
reboot
restart the switch same effect as physically
turning off the power
remove ip=<ipaddress>
mask=<netmask>
delete a specific IP address from the access or
trusted host list
remove mac=<all|address|list|range>
port=<num|list|range>
remove a MAC address entry
removeall
remove all IP addresses of trusted hosts
reserve-ip ip=<ip> [mac=<mac>]
reserve a specific IP address for a device
310
