M A G N U M 6 K S W I T C H E S , M N S - 6 K U S E R G U I D E
Magnum6K25#
set secrets hide
Secrets will be hidden.
Magnum6K25#
set secrets show
Secrets will be visible.
Magnum6K25#
F
IGURE
47
– Hide or display system passwords
Erasing configuration
To erase the configuration and reset the configurations to factory default, you can use the
command
‘kill config’.
This command is a “hidden command” i.e. the on-line help and other help
functions normally do not display this command. The
‘kill config’
command resets everything to
the factory default. The reset does not take place till the switch reboots.
It is recommended to save the configuration (using
‘saveconf’
command
discussed above) before using the
‘kill config’
command. The
‘kill config’
will
also reset the IP address and all other parameters as well unless the save option
described below is used.
Syntax
kill config [save=module-name]
– resets the system configuration. The module-name
option does not reset the specific module parameters. The modules are
listed below
The module-names are
Name
Areas affected
system
IP Configuration, Boot mode, Users settings (e.g.
login names, passwords)
event
Event Log and Alarm settings
port
Port settings, Broadcast Protection and QoS
settings
bridge
Age time setting
stp
STP, RSTP, S- Ring and LLL settings
ps
Port Security settings
mirror
Port Mirror settings
sntp
SNTP settings
vlan
VLAN settings
gvrp
GVRP settings
snmp
SNMP settings
web
Web and SSL/TLS settings
tacacs
settings
auth
802.1x Settings
igmp
IGMP Settings
65
