Assembly instructions
®
Assembly instructions
3
4
a
b
1
2
1. Backset Determination
Backset is a distance from door edge to
centre of hole on door face.
Adjustable latch fits both backset of
2 3/8" (60 mm) and 2 3/4" (70 mm).
2.
Change Latch Face
Determine which latch mounting
method will
be used and
make necessary adjustments.
No adjustment required for square latch
face plate.
a. Use a flat screwdriver to separate the
face plate.
b. Snap selected latch face onto back plate.
2.1
5
4
3
Drive-in latch
Drive-in Installation
Remove original latch faceplate.
Align the
(F) as illustrated
and snap into the latch case.
drive-in sleeve
F
Replace the old lock with the new one
To replace the old lock with this product on
the same door, please confirm the backset
for the latch and that the specifications for
the face plate match. Please also refer to
the following instructions to adjust the
backset and face plate to match the existing
door's specifications.
3. Mark the Door with Template
Select the height and backset as desired on
the door face; use the TEMPLATE as an
indication to mark the centre of the circle on
the door face and the centre of the door
edge.
4. Drill Holes
Using the marks as a guide to drill a hole
Ø2 1/8" (54 mm) through the door face for
the lockset, then a hole of Ø1" (25.4 mm)
for latch.
5. Identify Door Handing
Face the door from the outside. The
door is left-handed if the hinges are
on the left side of the door, whereas
the door is right-handed if the hinges
are on the right side of the door.
4
Left-handed
Right-handed
Hinge
Hinge
model no.: 046-7247-4