11
11. Install Strike on Door Frame
Install the strike plate (G) into your door
frame and tighten with wood screws (L).
L
Hardware Used
Wood screws x2
L
G
8.1
E
Install Drive-in Latch
Drive the latch (E) into the hole on edge of
door.
Assembly instructions
®
Assembly instructions
7
8
Hardware Used
N
Mounting plate screws x2
model no.: 046-7247-4
E
10
9
9. Mark the Outline of Strike
Half-close the door so the latchbolt is
against the door frame.
Mark the position of faceplate as
Place the strike against the door frame and
mark its perimeter.
Make sure the centre of strike is perfectly
aligned with the centre of faceplate.
a guide.
10. Chisel Space for Strike
Drill a Ø1" (25.4 mm) hole with 1/2" (13 mm)
depth on the centre of strike outline.
Then use the chisel to
out the door
frame 1/16" (1.6 mm) deep within the
traced outline.
Make sure to chisel deep enough to allow
the strike to lay flush with the frame
surface.
gouge
12.
vertically
Install the Exterior Lock Body
Fit the spindle
through the square
cam of the latch.
Fit the cable through the cross bore above
the latch.
The spindle must be vertical.
13. Install the Mounting Plate
Pass the cable through the cable hole on top
of the mounting plate (H). Then fasten the
mounting plate (H) with screws (N).
Examine whether the exterior lock unit and
the mounting plate (H) are tilted.
If so, please loosen the screws for
adjustment, and re-fasten the screws.
N
H
12
13
