J
O
Cable
H
13.1
Assembly instructions
9
model no.: 046-7247-4
®
Assembly instructions
10
14
14.1
J
P
H
Wood screws or self-tapping screws may be
used if needed.
(Wood screws are used for wooden doors,
and self-tapping screws are used for metal
doors to keep the mounting plate from
moving. This will help keep the lock in
position.)
14. Install the Interior Lock Body
Push the battery cover (J) upward.
Connect the interior and exterior cables.
Align the interior lock unit to the spindle and
push it in (make sure the turn-piece is
horizontal) When the interior lock unit is
flush with the door, fasten with screws.
If the interior lock body cannot be flush with
the door, please push the cable into the
cross bore.
.
Hardware Used
P
Installation screws x3
Hardware Used
O
Wood screw
Self-tapping screw x1
x1 or
14.2
Install 4 AA alkaline batteries and close the
battery cover (J). Installation is complete.
Remarks:
(1) Alkaline batteries are recommended in
order to stabilize the power supply. If you
do not use alkaline, battery performance
will be reduced greatly.
(2) Do not mix the alkaline batteries with
regular zinc-carbon batteries and avoid
mixing batteries of different brands.
NOTIFICATIONS
1. During operation, if the red light on the battery cover blinks and
10 short beeps are heard, it means that the battery is low.
The batteries need to be replaced immediately.
2. All settings will be retained in the memory even if the batteries are
completed dead.
3. Do not use any chemicals or add any lubricant when cleaning the lock,
to avoid damaging the panel and coating.
4. In case of malfunction of the lock, please contact customer service
at 1-800-268-6591 to find the nearest location for service, maintenance
or repair.
