GB
|
Operating Instructions
2
Technical Data
The devices are manufactured in accordance with the provisions of EN 60745-1 and EN 60745-2-13 fully comply with
the provisions of the German Equipment and Product Safety Act..
Battery voltage/operation voltage
40 V DC
Guide Bar
305 mm / 12“
Cutting length
300 mm
Chain
91P045X / 91PX045X
Guide Bar Type
120SDEA041 Oregon
Speed
11 m/s
Battery type Li-Ion
40 V / 2,5 Ah / 100 Wh
R3-360-AH-U-02
Battery charger
R3-360-3A-02 Quick charger
R3-360-1A-02 charger
Runtime (no load)
ca. 40 min.
Weight
5,3 kg
Oil
180
ml
Sound Pressure Level L
pA (2000/14/EG)
88 dB(A) [
K 3,0 dB(A)]
Vibration
(EN 60745-2-13:2009)
3,5 m/s
2
[
K 1,5 m/s
2
]
1 Wear eye and ear protection!
2 Warning!
3 Read operation instructions before use
4 Do not subject this electric power tool to rain
5 Remove plug immediately if the power flex is damaged or cut.
6 Attention, kick-back!!
7 Hold tool with both hands!
8 Attention: Environmental Protection! This device may
not be disposed of with general/ household waste.
Dispose of only at a designated collection point.
9
Do not discard the battery pack fire and placed next
to the fire and flammable
10 Do not dispose of batteries in bodies of water or
immerse them in water.
11 Do not expose battery to temperatures above 40ºC.
12 Rechargeable battery contains lithium!
13 Recycle defective rechargeable batteries!
14 Guaranteed acoustic capacity level LWA 100dB(A)
Illustration and explanation of pictograms
1
2 3 4 5
6
7
8 9 10
11
12
13 14
Chain saw, battery powered AKS 4030
Emissions
-
The specified vibration emission value was measured by a standardized test methods and can compare with other
power tools are used.
-
The specified vibration emission value can also be necessary for the assessment of work breaks are used
.
-
The specified vibration emission value can vary during the actual use of the electric tool by specifying the value,
depending on the way how to use the power tool.
-
Note: You create the privilege against vascular pulsations of the hands in time breaks
-
Try to keep the stress due to vibration as low as possible. For example, measures to reduce vibration stress are
wearing gloves when using the tool and limiting the work time. All phase of the operating cycle must be considered
in this regard, (for example, times when the power tool is switched off, and times when the power tool is switched
on but is not running under load).
Summary of Contents for AKS 4030
