34
Table 3
Frequency of maintenance
Type of maintenance
Before starting the
engine
Fill the fuel tank with clean and fresh fuel mixture
prepared in the correct proportions. Check the
tightness of screw connections
Every 10 hours of work
Conduct maintenance of the air filter
Every 50 hours of work
or once a season
Check the condition of the spark plug and the gap
between its electrodes
If necessary
Clean the engine cooling system fins
WARNING! Maintenance must be performed regularly throughout the life of the
product. Without maintenance the buyer loses the right to the warranty.
Under normal operating conditions, the product will perform well all the guaranteed service life.
Adherence to recommended operating rules will allow you to avoid premature failure of individual parts
of the product and the product as a whole.
Maintenance in service centers is not included in the warranty obligations of the
manufacturer and the seller. Service centers provide paid services to carry out periodical maintenance.
After the end of the service life the product may be used for its intended purpose if its state
meets the safety requirements and the product has not lost its functional properties. Certificate is
issued by the authorized service centers of TM
GÄRTNER.
6 ROUTINE MAINTENANCE OF THE PRODUCT PARTS
6.1 Troubleshooting
List of possible problems and their solutions is given in table 4.
Table 4
Malfunction
Cause
Solution
Engine does
not start
Ignition switch is in "OFF"
position
Set ignition switch into "ON" position
Empty fuel tank
Fill the tank with fresh, clean fuel mixture
Fuel pumping knob is
pressed insufficient number
of times
Press manual fuel pumping knob 5-7 times up
to the stop
Carburetor "lets the fuel
overflow" (by the wrong start
order)
Repeat the starting procedure, setting
carburetor choke lever into the position "fully
open"
Old or improperly prepared
fuel mixture
Drain the old oil. Fill with fresh, clean fuel
mixture
Faulty spark plug
Clean or replace the spark plug
Big length of cutting string
Reduce the string length up to the size of the
guard
Engine is
unstable
idling
Dirty air filter
Clean or replace the air filter
Old or improperly prepared
fuel mixture
Drain the old oil. Fill with fresh, clean fuel
mixture
Engine is not
gaining
speed
Old or improperly prepared
fuel mixture
Drain the old oil. Fill with fresh, clean fuel
mixture
Carburetor is not adjusted
Contact a service center for complex
adjustment of the carburetor
Summary of Contents for BCG-2917
