ANITA ©
Serie GF-105
10
5. Lubrication Adjustment of Hook
A. Checking the oil supply level of Hook
a) After racing the sewing machine for three minutes, secure the oil flowchecking paper as shown in
Fig and run the machine for about five seconds. Ten check the oil tape marked on the paper.
b) Check the oil supply level three times. The
appropriate level of oil is when the oil level neither
exceeds the maximum amount nor falls below the
minimum level. (Insufficient oil would jam the hook,
whereas excessive oil would contaminate the
sewing material with oil)
B. Adjustment of the Oil Supply Level
Turn the oil flow adjusting screw (1) in the lower
shaft front bushing in a clockwise direction for
more oil flow. Turn it counterclockwise for less oil.
www.garudan.cz
Summary of Contents for GF-105 Series
