ANITA ©
Serie GF-105
15
12. Stitch lenght Adjustment
As is shown in Fig.21, the number marked by the stitch adjusting dial (1) signifies the stitch lenght in
mm units. Move the dial sideways to set it to the desired stitch lenght (Turn it in clockwise direction
and the stitch lenght will decrease while turning it counterclockwise will increase the stitch lenght).
Fig.21
13. Height and Inclination Adjustment of Feed Dog
A. Height adjustment of the feed dog
The height of the feed dog is adjusted by moving the lifter crank (1) after the lifter crank fixing screw
(2) is loosened. The standard height from the top face of the needle plate to the top of the feed dog
when the stitch lenght dial is at its maximum and the feed dog is at its highest point is shown in Fig.22.
Fig.22
B. Inclination adjustment of the feed dog
a) The standard tilt of the feed dog is obtained when
marker dot (A) on the feed bar shaft is aligned with
marker dot (B) on feed rocker (1). (Fig.23)
Fig.23
www.garudan.cz
Summary of Contents for GF-105 Series
