ANITA ©
Serie GF-105
16
14. Feed Cam Adjustment
15. Timing adjustment of Trimmer
Fig.25
A. Adjusting the position of the thread trimming cam
If you run the handwheel of the machine, the needle bar goes fromthe bottom up to 5 mm, then the
thread trimming solenoid (4) is pressed to impel the roller ball touchs to the concave of the thread
trimming cam (1). Then use the position screw (2) to tighten it in casual. And then replace the thread
trimming solenoid (4), while loose the csrew (2) to adjust the cam (1), the clearance of the end plane
between the cam and thread trimming driving shaft is 0,5 mm.
B. Adjusting the position of the counter knife and moving knife.
When the head of the thread trimming driving shaft (3)exceeds the cam, the mesh between the front
plane of the counter knife (8) and the edge of the moving knife (7) is 0,2-0,5 mm. If they are not
meshed, moves the knife shaft crack rod (6) before the thread trimming driving shaft exceeded the
cam (1), the front plane of the counter knife (8) and the edge of the moving knife is meshed, the
tighten the screw (5).
Fig.24
www.garudan.cz
Summary of Contents for GF-105 Series
