ANITA ©
Serie GF-105
7
2. Machine head
1) Machine head
Oil tray should be put at the four corners of the slot in the table plate. Fix two arm cushion 1 to the
A side of oil tray 3. Fix the two stand bases 2 to the B side of oil tray 3, then fix the oil tray 3 (Fig.
1, 2). Plug the hinge 1 into hole of bed plate, put the machine head on the table plate, hinge at the
sink place and then fix the machine head on cushions of the four oil tray corners (Fig. 3,4)
3. Lubrication
A) Installing Magnetic Chip Remover
Attach the magnetic chip remover that is in the accessory box to the oil pump imide the bed.
* Do not use the magnet for other purposes. Use of the sewing machine without the magnet may
cause malfunction and has a bering on the machine´s durability.
B) Lubricating the oil pan
a) Fill the lubrikant up to the „HIGH“ mark.
c) If the oil in use is down to the „LOW“
mark, fill in to „HIGH“ immediately.
Fig.5
www.garudan.cz
Summary of Contents for GF-105 Series
