ANITA ©
Serie GF-105
9
4) CONTROL AND ADJUSTMENT OF THE SEWING
MACHINE
1. Needle Insertion
With the needle groove (1) facing left, insert the needle tip into the
upper end of the stoper hole (2) and osten the needle with the
clamp screw (3). (Figbr.9)
Fig.9
2. Needle Bar Adjustment
As is shown in Fig. 10, unscrew the ruber plugs
(4) in the needle bar adjustment hole that is on the
face plate and turn the pulley so that the needle
bar is in down-stop position. Then turn loose the
clamp screws (5) on the needle bar handle, move
the needle bar such that the lowest carved sign on
the needle bar (7) is in line with the bottom of the
needle bar lower bushing (6) and tighten the
clamp screws of the needle bar handle. Lastly
plug in the rubber plugs (4). (Fig.10)
Fig.10
3. Timing adjustment of Needle and
Hook
As can be seen in Fig.10, alig the bottom of the
needle bar bushing (6) with the hook fixed position
sign (1) marked on the needle bar and loosen the
three hook fixing screws (2). Turn the hook so that
the edge of the hook (3) is in line with the needle
center. Adjust such that the distance between the
inside of the groove on the needle side and the
edge of the hook (3) is 0,05-0,1 mm, the tighten
the three fixing screws (2) again. (Figobr.10)
4. Lubrication Adjustment of Thread
Take-Up Lever
Oil flow is at its maximum when the mark (2) on
the head of the oil flow control pin (1) and the
center of the hole (3) on thread take-up lever
crank shaft is directly aligned (Fig.11)
Fig.11
www.garudan.cz
Summary of Contents for GF-105 Series
