ANITA ©
MP02300EN_170818
20
22.
Needle-to-hook relationship
1. Turn the hand- wheel to bright the needle bar down to the lowest point of its stroke, and loosen
setscrew ①.
2. Adjusting the needle bar height:
1) While using DB needle, align marker line A with bottom end of needle bar lower bushing ③, then
tighten setscrew ①.
2) While using DA needle, align marker line C with the bottom end of needle bar lower bushing ③,
then tighten setscrew ①.
3. Locate the hook position:
1) While using DB needle, loosen the three hook set screw , turn the hand-wheel, and align marker
line B on ascending needle bar ② with the bottom end of needle bar lower bushing ③.
2) While using DA needle, loosen the three hook set screw, turn the band-wheel, and align marker
line D on ascending needle bar ② with the bottom end of needle bar lower bushing ③.
4. After making the adjustments mentioned in the above steps, align hook blade point ⑤ with the
center of the needle ④, provide a clearance of 0.04mm to 0.10mm (reference value) between the
needle and the hook, then securely tighten setscrews in the hook.
Caution
:
1. If the clearance between blade point of hook and the needle is smaller than the
specified value, the blade point of hook will be damaged. If the clearance is larger,
stitch skip-ping will result.
2. Use a hook of the same part No. When replacing your hook with a new one.
www.garudan.cz
Summary of Contents for GF-1107-147 MH
