© ANITA
MP03100EN_180912
11
10. ADJUSTING THE OIL IN THE PUMP
When it's running at low speed, observe the oil
window. If you don't see the oil spraying, please turn
the oil-supplied regulating plate (1) and cover the oil
hole (2). See Fig. 7.
11. ATTACHING THE NEEDLE
Turn the upper wheel and make it at the top place.
See Fig. 8.
Loosen the screw (2).
Insert the needle (3) into the bottom (till touch the
bottom), and make sure the long groove left, then
tighten the screw (2).
12. SETTING THE BOBBIN CASE
The needle should at the top place when install the bobbin case. First pull the bobbin cover (1), then
put the bobbin core into the hook. Please make sure the batter board match with the locating slot
when you put the bobbin core. See Fig. 9
Please make sure to open the bobbin door when you replace the bobbin core. Then hold the bobbin
door and replace the bobbin core slowly. So that can make the bobbin bush tight the bobbin core.
And will not drop
Figure 7
Figure 8
Figure 9
www.garudan.cz
Summary of Contents for GF-3131-447 MH
