© ANITA
MP02800EN_180126
11
The bobbin fills up during sewing.
•
The tension of the thread on bobbin 1 can be adjusted with knurled screw 4.
•
The bobbin winder stops automatically when bobbin 1 is full.
•
Remove the filled bobbin 1 and cut the thread on knife 5.
If the thread is wound unevenly, loosen nut 6 and turn thread guide 7 accordingly.
Retighten nut 6 after the adjustment.
6.03 REMOVING/INSERTING THE BOBBIN CASE
Switch the machine off! Danger of injury if
the machine is started accidentally!
Removing the bobbin case:
•
Open the post cap.
•
Raise latch 1 and remove bobbin case 2.
Inserting the bobbin case:
•
Insert bobbin case 2.
•
Close the latch and close the post cap.
Fig. 12
6.04 THREADING THE BOBBIN CASE/ADJUSTING THE BOBBIN THREAD TENSION
Insert the bobbin into the bobbin case 1
Pass the thread through the slot under spring 2.
Pass the thread through the notch.
Adjust the thread tension by turning screw 3.
Fig.13
www.garudan.cz
Summary of Contents for GP-110-147
Page 18: ......
