Preparation
——————————
7
Setting up
All instructions and regulations in this instrution manual must be
observed .
Special attention must be paid to all safety regulations!
All setting-up work must only be carried out by personnel with the appropriate training.
For all setting-up work the machine must be disconnected from its power supply by
turning off the on/off switch, or
removing the plug from the electric power socket.
7.01 Inserting needle on model GP710-108
Switch the machine off!
Danger of injury if the machine is started
accidentally!
Only use needles of system
134
●
Raise the roller presser
1
and swing it out.
●
Loosen screw
2
and insert the needles as far as possible.
The long groove must face to left on model GP-710.
●
Tighten screw
2
and swing roller
presser
1
back to position.
The Choice of needle depends on the model of the machine and the thread and material used (see
Chapter
3.02 Needles and threads
).
www.garudan.cz