Adjustment
——————————
9.04.04
Position of the thread catcher
●
Move thread catcher
1
(screw
2
, two screws) in accordance with
Requirement 1
.
●
Turn thread cather
1
(screw
3
) in accordance with
Requirement 2.
Thread catcher
1
must be parallel to the surface of the thread catcher holder
4
.
Requirement
1. the bottom edge of the thread catcher
1
should be at a distance of
0.1 mm
from the positioning finger of the bobbin case
5
.
2.
when the thread trimmer is in its neautral position, the rear edge of
thread cather should be positioned approx.
2.5 – 3 mm
behind the
edge of the knife.
www.garudan.cz
