ANITA ©
MP00006EN_181206
14
4.4
Setting of continuous mode:
This mode can only be used for firmware version 0.25 and higher. Continuous mode is characterized
by automatic start of sewing of the same pattern after previous sewing of this pattern has been
finished, without necessity of pushing either the pedal or SEWING START button. Pause between the
two operations can be set within the range of 0.1 to 320 sec. This mode is mostly used for operations
where the feeding frame consists of more pieces, each of which can be removed and replaced after
being sewn without necessity of lifting the feeding frame. However, scope of use of this function is
much broader.
Continuous mode is activated by pushing the button
Continue
(A – picture 8) on the screen for
sewing. Window B will appear (see picture 8). Red color of circle C indicates deactivation of
continuous mode, green color stands for activated continuous mode.
Activation of continuous mode is made by pushing the button
On/Off
(D - picture 8). In next window,
it is possible to set time gap between two operations within the range 0.1- 320 sec. While this mode
is activated, red color note Continuous running is being displayed on the screen (F - picture 8).
Deactivation of continuous mode is made by pushing the button
On/Off
(D - picture 8) and by setting
values for time gap in next window to zero. By simply pushing the button
Close
(E - picture 8) or cross
in the upper right corner, function of continuous mode is not deactivated.
Picture 8: Screen for setting of continuous mode
www.garudan.cz
Summary of Contents for GPS/G-10060
Page 69: ......
