ANITA ©
MP00006EN_181206
16
5.
MONITORING OF LOWER BOBBIN
For this function we have two ways: 1. we don´t know the number of patterns which we need to sew
at full bobbin and 2. we know the number of patterns which we need to sew at full bobbin.
We don´t know the number of patterns
a)
insert full bobbin in the bobbin case of the hook
b)
press key
Start
– the key automatically changes to
Stop
c)
sew the patterns and see the amount of the counter (
Actual
) and wait till the bobbin is
empty
d)
press key
Stop
e)
value from
Actual
have been replaced by
Total
minus 1
f)
now replace the bobbin and you can sew
g)
at sewing you can see increased number of sewn patterns at current bobbin (
Actual
) and
also you see decreased value of rest of patterns (
Rest
).
h)
when the value
Rest
is 0, the value
Actual
is equal with
Total
. The machine is blocked and
you can see message about empty bobbin. Press key
Ok
.
i)
by pressing
Ok
you set monitoring of lower bobbin again and continue
We know the number of patterns
1.
insert full bobbin in the bobbin case of the hook
2.
press key
Set
and set the number of patterns which we are able to sew at full bobbin.
Confirm by pressing
Ok
.
3.
adjusted value was replaced by value
Total
.
4.
sew and you can see increased number of sewn patterns at current bobbin (
Actual
) and also
you see decreased value of rest of patterns (
Rest
)
5.
when the value
Rest
is 0, the value
Actual
is equal with
Total
. The machine is blocked and
you can see message about empty bobbin. Press key
Ok
.
6.
by pressing
Ok
you set monitoring of lower bobbin again and continue
Iterative setting of monitoring you can make anytime by pressing key
Clear
.
By pressing key
Set
you can change the value
Total
.
By pressing key
Set
and changing the value
Total
at 0 you turn off the monitoring.
www.garudan.cz
Summary of Contents for GPS/G-10060
Page 69: ......
